Hi

I recently purchased a Prosistel PST-641D and I am trying to wire it up unfortunately the guy I bought it from cut the cable off at the rotator.

When i checked the plug which is a 7pin round there are no pin numbers on it, can anyone help me with this, as I can find no information on it.

I have emailed Prosistel but am still waiting for a reply.

Also any ideas where I could get another one, 35 Euros from Prosistel, not keen on paying that.

Regards

Phil.

Look again at that plug, is it not 5 pin?

Pretty sure these wire 1-1 with the controller, so shouldn't be too difficult to figure out.

Should have added, Prosistel are quite responsive, ping them an email and ask for the wiring.

Definitely 7pin.

I have emailed Prositel, just thought I would ask on here as I want to get up and running as soon as I can.

Controller uses a different plug, 5pin mic.

Use a magnifying glass if need but but there is pin numbers on the plug.

Used a torch and a magnifying glass.

Sorted, thanks.

Good, because this was going to be my next move.

Is it the 'D' Controller ?

Thanks for all the help guys.

I have got the pin numbers sorted now.

Phil.

This will help you test the cable